CoolPoly
thermally conductive injection molding grade
thermoplastics are ideal solutions for applications
involving heat transfer and thermal cycling.
Microtiter and similar tubes and trays
used for PCR (Polymerase chain reaction) are
injection molded from CoolPoly E1201 thermally
conductive polypropylene. E1201 has been formulated
to offer the following advantages compared to
conventional polypropylene.
CoolPoly
E1201 has a thermal conductivity approximately 50
times the conductivity of conventional
polypropylene. As a result, heat is efficiently
transferred through the wall, drastically reducing
the time required for each thermal cycle.
The
temperature profile of the fluid precisely
reproduces the intended profile of the thermal
cycler. The wall temperature is uniform even with
thickness variation. E1201 was formulated to provide
low background emissions significantly enhancing the
signal-to-noise ratio and the sensitivity of the
measurement.
CoolPoly
thermally conductive injection molding grade
thermoplastics are well suited for molding 3-dimensional net
shape plastic molds used in the manufacture of other products.
>>More
used for PCR (Polymerase chain reaction) are
injection molded from CoolPoly E1201 thermally
conductive polypropylene. E1201 has been formulated
to offer the following advantages compared to
conventional polypropylene.
thermoplastics are well suited for molding 3-dimensional net
shape plastic molds used in the manufacture of other products.
>>
401-739-7602 | 888-811-3787 US
Toll free |